Selecting and Deselecting a Stack |
| You can select a particular stack in
your workspace in two ways: by clicking on its name in the stacks dialog,
or by using the magnet tool. The magnet tool is normally used to select
and move the stack where you click but the stack must be visible and at
the front in the current view for the selection to take place.
The magnet tool can also be used to move the stack once selected. For more information on changing stack locations refer to the next section on adjusting stack position. From the stacks dialog you can select multiple stacks by holding down the control key. Clicking on a stack while the Control key is being held down toggles the selection state of a stack. To select a contiguous range of stacks hold down the Shift key while you click on any two stacks. This will select the two stacks and any stacks in between. To deselect all stacks use Deselect All from the Edit menu. |